Show command help

Unanswered Question
Nov 27th, 2007

when i try to find specific item in the sh run i should use more parameters like the following

show run | include (interface |

Is there any DOCs on cisco explain the show command with detailed parameters?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
glen.grant Tue, 11/27/2007 - 16:52

Learn to use the "pipe" command , it comes in very handy when looking for particular things in a config . You can pipe almost any parameter from show ip route to just about any "show command. . If you have say a large config and you want to look for something in particular say like snmp parameters instead of going theu the whole config use like " show runn | begin snmp and that will take you to the snmp area in the config directly. Pipe is your friend to save some time.

welcomeccie Wed, 11/28/2007 - 06:41

How can i display interafec vl 25 and it ip only . I tried to use

show run | inc (interface | but it gives me all the interfaces too

welcomeccie Wed, 11/28/2007 - 10:33

Suppose that i know the ip address but i don't know the vlan number


This Discussion