Timeout troubles...

Unanswered Question
Nov 27th, 2007
User Badges:

Me again,

Still having a bit of difficulty in the arena of configuring a PIX to replace failing hardware. I've gotten most everything else resolved, however, I'm in a bind with a unneeded timeout entry.

These are the entries I have when I run "show timeout":

timeout xlate 3:00:00

timeout conn 1:00:00 half-closed 0:10:00 udp 0:02:00 rpc 0:10:00 h225 1:00:00

timeout h323 0:05:00 mgcp 0:05:00 sip 0:30:00 sip_media 0:02:00

timeout sip-disconnect 0:02:00 sip-invite 0:03:00

timeout uauth 0:05:00 absolute

The new PIX is pushing IOS version 6.3(5) and the entry I'm looking to remove (not listed in the current PIX's config) is the one:

"timeout sip-disconnect 0:02:00 sip-invite 0:03:00"

Any advice will help... Thanks in advance!

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
whisperwind Wed, 11/28/2007 - 12:58
User Badges:

Those are defaults I do not 'think' they can deleted permanently, not sure why it would matter if your security policy does not permit these protocols these values are never used.


This Discussion