CatOS to IOS on 6509

Unanswered Question
Nov 28th, 2007
User Badges:

I need to convert our config on the 6509 from CatOS to IOS. Have anyone used the Cisco EDI CatOS to IOS configuration Tool? Is it worth using it or should I just do this conversion manually? Any suggestions what to look out for would be greatly appreciated. I have never done this before so any advise would be great.



WS-C6509 Software, Version NmpSW: 8.3(4)


System Bootstrap Version: 8.1(3)

System Boot Image File is 'bootflash:cat6000-sup720k9.8-3-4.bin'


cat6509> (enable) sh module

Mod Slot Ports Module-Type Model Sub Status

--- ---- ----- ------------------------- ------------------- --- --------

1 1 24 1000BaseX Ethernet WS-X6724-SFP yes ok

2 2 48 10/100BaseTX Ethernet WS-X6148-45AF yes ok

3 3 48 10/100/1000BaseT Ethernet WS-X6548-GE-TX yes ok

5 5 2 1000BaseX Supervisor WS-SUP720-BASE yes ok

15 5 1 Multilayer Switch Feature WS-SUP720 no ok

6 6 2 1000BaseX Supervisor WS-SUP720-BASE yes standby

16 6 1 Multilayer Switch Feature WS-SUP720 no standby

7 7 8 Network Analysis Module WS-SVC-NAM-2 no ok

8 8 8 Intrusion Detection Mod WS-SVC-IDSM-2 yes ok

9 9 6 Firewall Module WS-SVC-FWM-1 no ok



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

I have converted 16 6509's using the manual documentation, and in the beginning had problems, mostly because I went out of sequeunce by reading to far ahead. Then configured each module. You have several modules installed that I didn't have, so it might be more time consuming and open to errors using the manual approach.


I realize this might not be the answer your seeking, but I found for our configuration, manual was better, and longest conversion took 30 minutes.


Dave

Actions

This Discussion