PGW and AS5400

Unanswered Question
Nov 29th, 2007

Hi all,

I have a solution that connect 2 pgw's with one as5400, the TDM switch that have ss7 are connected to the as5400, and they use the TS 1 for signaling, I have configured my as5400 e1 as follow:

controller E1 1/0

framing NO-CRC4

pri-group timeslots 1-31 nfas_d primary nfas_int 0 nfas_group 0 rlm-group 0 !

interface Serial1/0

no ip address


interface Dchannel1/0

no ip address

encapsulation hdlc

isdn incoming-voice modem

no isdn send-status-enquiry

isdn negotiate-bchan resend-setup

no cdp enable


My questions are 2:

1.- how to change the ts 1 to be used for signaling mode instead of use 16?

2.- I'm using nailed mode, so, do I have to create all trunks in my pgw? and also have to create my d channels in the pgw?

Hope that you can help me


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 3 (1 ratings)
teodorgeorgiev Sat, 12/08/2007 - 04:32

The reply of Crieman was obviously useful, so I vote for it instead of the guy who asked the qusetion.


This Discussion