Hi all,
I have a solution that connect 2 pgw's with one as5400, the TDM switch that have ss7 are connected to the as5400, and they use the TS 1 for signaling, I have configured my as5400 e1 as follow:
controller E1 1/0
framing NO-CRC4
pri-group timeslots 1-31 nfas_d primary nfas_int 0 nfas_group 0 rlm-group 0 !
interface Serial1/0
no ip address
!
interface Dchannel1/0
no ip address
encapsulation hdlc
isdn incoming-voice modem
no isdn send-status-enquiry
isdn negotiate-bchan resend-setup
no cdp enable
!
My questions are 2:
1.- how to change the ts 1 to be used for signaling mode instead of use 16?
2.- I'm using nailed mode, so, do I have to create all trunks in my pgw? and also have to create my d channels in the pgw?
Hope that you can help me
Regards
