7911 localisation to English

Answered Question
Nov 30th, 2007


I have a 7911 IP Phone which is in Korean language. I want to change the language to english. My current CME system localisation is in default english. How can i change this phone text to english???

All my other IP phones are displaying in english.Only this is giving the problem.

I tried adding command user-locale US and network-locale US in telephony-service but still doesnt work.

do i need to add a EN language pack??? Pls advice.



Correct Answer by Paolo Bevilacqua about 9 years 1 month ago

You are welcome. Please rate useful posts with the scrollbox below!

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
hadbou Fri, 12/07/2007 - 07:19

We also have to post the localisation download files for these phones to a CCO download page. Unlike the 7960/7912, the localisation dictionaries are not built in to the CME IOS image. These files just need to be loaded into the router's flash, with the appropriate tftp-server commands.

netstar-sg-service Mon, 01/28/2008 - 02:21


I have tried putting the English language pack also. Still it showing half in english and half menus in korean.

Pls assist.. urgent.


Paolo Bevilacqua Mon, 01/28/2008 - 05:21


try a factory reset. Remove power. Reapply while pressing #. Release # when LED flashed in pattern. Press sequence: 123456789*0#

Phone will completely reset and reflash.

Note you need need to have term11.default.loads, and all the associated firmware files on the CME router, and the "tftp-server" commands for all of them.

Hope this helps, please rate post if it does!


This Discussion