L3 Routing

Unanswered Question
Nov 30th, 2007


Follows the instruction to implement L3 routing below:


However, the part where I have to alter one switch port to a routed port is causing problems. As soon as I do that I cannot access the network connected to the router.

However if I connect the router to the switch on a dot1q trunk port, then everything works fine.

I have configured VLAN1 with an ip address and issued ip route commands to the Router.

Can someone clarify?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
glen.grant Fri, 11/30/2007 - 05:55

If you are using the vlan 1 SVI for the ip address then your connecting port would be a switchport not a routed port . If you want to use the actual port as a routed port then get rid of the int vlan 1 ip address and put that on the routed port (no switchport) that you configure .


This Discussion