cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
317
Views
0
Helpful
2
Replies

New internet circuit not working with IDS

jweitman1
Level 1
Level 1

We are upgrading out internet to a bonded t-1. Two new circuits have been installed. For some reason, the IDS will not allow internet traffic via the new circuits. Everything is exactly the same from a IP address/Network standpoint. The only difference is the Ethernet port speed coming out of the new router going into our switch is 100meg and the old router is 10meg? Not sure if that is the problem or not. Any help/suggestions would be appreciated.

2 Replies 2

scothrel
Level 3
Level 3

Make sure your IPS port is in auto-negotiate mode. You might have had to explicitly config it to 10M to get that speed before.

I have had them set it to 10meg and we are going to try it again at noon today. I will post the results. Thanks.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: