cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3053
Views
0
Helpful
4
Replies

3750 rommon xmodem command unknown

neil
Level 1
Level 1

I am trying to xmodem an image to flash but when I enter the command in rommon to xmodem. I receive:

switch: xmodem

Unknown cmd: xmodem

Not sure why I am getting this. It has always worked in the past.

4 Replies 4

Collin Clark
VIP Alumni
VIP Alumni

It's been a while since I had to do that, but don't you invoke XMODEM through the terminal emulator (ie SecureCRT)?

I got it

I did copy xmodem[filename] flash:[filename]

That seemed to work

Edison Ortiz
Hall of Fame
Hall of Fame

The routers using the command xmodem while the switches use the command copy xmodem..

glen.grant
VIP Alumni
VIP Alumni

I can also advise you to set the baud rate on the switch and the terminal emulator to 115200 , this will take a download of code of this size from like 2 hours down to like 15 minutes .

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: