11-30-2007 08:11 AM
Preempt is not working
- It is configured as default on primary and disabled on secondary, it appears correctly in sh ft group x detail
The failover appears to work as far as FT is concerned.
The two start out as
Primary:
My State : FSM_FT_STATE_ACTIVE
My Config Priority : 200
My Net Priority : 200
My Preempt : Enabled
Peer State : FSM_FT_STATE_STANDBY_HOT
and
Secondary
My State : FSM_FT_STATE_STANDBY_HOT
My Config Priority : 95
My Net Priority : 95
My Preempt : Disabled
Peer State : FSM_FT_STATE_ACTIVE
When the primary is reloaded, the secondary appears as follows:
My State : FSM_FT_STATE_ACTIVE
My Config Priority : 95
My Net Priority : 95
My Preempt : Disabled
Peer State : FSM_FT_STATE_UNKNOWN
When the primary comes up again, it's state is as follows:
My State : FSM_FT_STATE_STANDBY_HOT
My Config Priority : 200
My Net Priority : 200
My Preempt : Enabled
Peer State : FSM_FT_STATE_ACTIVE
Note, preempt is enabled but it's still in standby state.
I have to do a manual switchover which works fine.
Any suggestions for this problem?
Solved! Go to Solution.
11-30-2007 12:51 PM
I believe that for preempt to work correctly on ACE, it must be configured on both side.
Could you give it a try ?
Tx.
Gilles.
11-30-2007 12:51 PM
I believe that for preempt to work correctly on ACE, it must be configured on both side.
Could you give it a try ?
Tx.
Gilles.
11-30-2007 01:37 PM
Will do so tomorrow.
12-01-2007 07:30 AM
That has worked.
Merci Encore.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: