Router config

Answered Question
Nov 30th, 2007
User Badges:

This is a simple one. how how I reduce the time so the the telnet session won't time out on me?


Also, how do I get the router not to display or echo a statement after I do any modification. For example, after I change the configuration on an interface, the router echos the following: *Nov 30 09:14:25: %SYS-5-CONFIG_I: Configured from console by cisco on console". How do I disable the router from displaying this?


Thanks in advance,

sK

Correct Answer by Collin Clark about 9 years 5 months ago

For changing the telnet timeout. Try the following:


Router(config)#line vty 0 4

Router(config-line)#exec timeout 30


The 30 in the above statement is idle minutes before disconnect.


To remove any messages, type the following:


Router(config)#no logging monitor


HTH and please rate.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Collin Clark Fri, 11/30/2007 - 09:46
User Badges:
  • Purple, 4500 points or more

For changing the telnet timeout. Try the following:


Router(config)#line vty 0 4

Router(config-line)#exec timeout 30


The 30 in the above statement is idle minutes before disconnect.


To remove any messages, type the following:


Router(config)#no logging monitor


HTH and please rate.

Edison Ortiz Fri, 11/30/2007 - 10:16
User Badges:
  • Super Bronze, 10000 points or more
  • Hall of Fame,

    Founding Member

Actually, the command is


no logging console


no logging monitor affects all monitored connections which include any SNMP logging traps among other things.

skhirbash Fri, 11/30/2007 - 22:43
User Badges:

You are correct. The no logging monitor didn't work but the no logging cosole worked.


Thanks,

sK

Collin Clark Mon, 12/03/2007 - 06:40
User Badges:
  • Purple, 4500 points or more

no logging monitor will shut off the messages during a telnet session and you got the console one figured out.

Actions

This Discussion