12-01-2007 01:17 PM - edited 03-05-2019 07:45 PM
Dear Invisible Mentors,
By looking at the following SH VER from my 2621 series, I'm i correct by saying the router has
64MB of DRAM? and 16MB of flash?. Please correct me if wrong and show me how to recognize the amount of DRAM and FLASH in the future.
Thanks
The show ver
cisco 2621 (MPC860) processor (revision 0x102) with 61440K/4096K bytes of memory
Processor board ID JAD042705K9 (204402121)
M860 processor: part number 0, mask 49
Bridging software.
X.25 software, Version 3.0.0.
2 FastEthernet/IEEE 802.3 interface(s)
32K bytes of non-volatile configuration memory.
16384K bytes of processor board System flash (Read/Write)
Configuration register is 0x2102
12-01-2007 02:18 PM
Yes, very closed with DRAM info
This is the flash size ( 16 MB flash )
16384K bytes of processor board System flash (Read/Write)
This is the RAM ( 65 MB RAM)
cisco 2621 (MPC860) processor (revision 0x102) with 61440K/4096K bytes of memory
Rgds
Jorge
12-01-2007 02:35 PM
Hello Jorge,
Thanks a lot for the prompt response. can you please tell me how you arrived at 65MB of RAM? for the flash (its clear to me)
Is there anything like 65MB of RAM?
Thanking you in advance,
Regards
12-02-2007 05:20 AM
It's actually 64MB: 61440K + 4096K = 65536K
Then 65536K / 1024 = 64MB
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide