Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
507
Views
0
Helpful
4
Replies

GRE Problem

rmujeeb81
Level 1
Level 1

‎12-03-2007 01:24 AM - edited ‎03-03-2019 07:46 PM

Hello,

I am facing problem in establishing GRE tunnel.Problem is that both remote routers are able to reach respective tunnel destinations and tunnel interface and protocol are UP but I can't ping P2P ip addresses of tunnel.Kindly guide me

Regards,

Mujeeb

Labels:
0 Helpful
4 Replies 4

royalblues
Level 10
Level 10

‎12-03-2007 02:44 AM

Can you post the end router configurations

Narayan

0 Helpful

nordick26
Level 1
Level 1

‎12-03-2007 02:56 AM

Try to use some debug commands.

e.g. debug tunnel

If doesn't help, provide more info about you architecture and config, maybe we'll find a "worm" in between.

0 Helpful

rmujeeb81
Level 1
Level 1
In response to nordick26

‎12-03-2007 03:39 AM

Hi,

I would like to add that WAN connections at both locations are DSL based.Routers are coonected with DSL modems over ethernet.When I try to establish GRE over an IPoA connection then it works but when I try over PPPoE in which MTU set at modem is 1492 then GRE doesn't work.

Regards,

Mujeeb

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card