12-03-2007 01:24 AM - edited 03-03-2019 07:46 PM
Hello,
I am facing problem in establishing GRE tunnel.Problem is that both remote routers are able to reach respective tunnel destinations and tunnel interface and protocol are UP but I can't ping P2P ip addresses of tunnel.Kindly guide me
Regards,
Mujeeb
12-03-2007 02:44 AM
Can you post the end router configurations
Narayan
12-03-2007 02:56 AM
Try to use some debug commands.
e.g. debug tunnel
If doesn't help, provide more info about you architecture and config, maybe we'll find a "worm" in between.
12-03-2007 03:39 AM
Hi,
I would like to add that WAN connections at both locations are DSL based.Routers are coonected with DSL modems over ethernet.When I try to establish GRE over an IPoA connection then it works but when I try over PPPoE in which MTU set at modem is 1492 then GRE doesn't work.
Regards,
Mujeeb
12-03-2007 06:10 AM
Reffer to this link: http://www.cisco.com/en/US/tech/tk827/tk369/technologies_white_paper09186a00800d6979.shtml
BR
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide