cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
746
Views
4
Helpful
6
Replies

cisco 7200 error message

v.matiakis
Level 1
Level 1

Hi, I've got an error message saying enqueued to process level.I am trying to find something in the cisco site but i do not seem to succeed anything. Does anyone know what this error means?

6 Replies 6

paolo bevilacqua
Hall of Fame
Hall of Fame

Please report the message in full, and the circumstances under which it is occurring.

the platform is Cisco 7206VXR running Version 12.3(9) IOS SOFTWARE. The error message is reapeating :

Version 12.3(9) and it appears in the log.

Dec 3 14:30:00: Enqueued to process level.

Dec 3 14:30:00: Enqueued to process level.

Dec 3 14:30:00: Enqueued to process level.

Dec 3 14:30:00: Enqueued to process level.

Dec 3 14:30:00: Enqueued to process level.

Dec 3 14:30:00: Enqueued to process level.

Dec 3 14:30:00: Enqueued to process level.

Dec 3 14:30:00: Enqueued to process level.

Dec 3 14:30:00: Enqueued to process level.

Dec 3 14:30:00: Enqueued to process level.

Dec 3 14:30:00: Enqueued to process level.

Dec 3 14:30:00: Enqueued to process level.

Dec 3 14:30:00: Enqueued to process level.

Dec 3 14:30:00: Enqueued to process level.

Dec 3 14:30:01: Enqueued to process level.

Dec 3 14:30:01: Enqueued to process level.

Dec 3 14:30:01: Enqueued to process level.

Dec 3 14:30:01: Enqueued to process level.

Dec 3 14:30:01: Enqueued to process level.

Dec 3 14:30:01: Enqueued to process level.

Dec 3 14:30:01: Enqueued to process level.

etc....

Hi,

Some packets are being handled at process level instead of interrupt time.

This can be due to configuration, features enabled, or packet properties.

In any case the message should not be printed.

Suggest you upgrade to latest maintenance for 12.3 and chances are the message will go away.

i see the following in the configuration :

ip flow-cache timeout inactive 30

ip flow-cache timeout active 1

could this have to do anything with the error?

Not necessarily. This type of spurious messages without a proper identification, are caused by programmers forgetting to remove debugging output. This is why upgrading is recommended.

I am now seeing the same issue in 12.4(15) on a 7201 ;

IPFLOW: Error sending export packet: Enqueued to process level

IPFLOW: Sending UDP export pak 948646533 to 10.10.10.10 port 9995 reason 2

Can you be more specific on the cause ?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco