How can I configure WPA on an 877w?

Unanswered Question
Dec 5th, 2007
User Badges:

Hi, I have an 877w configured in VPN mode to my HQ. All works fine. Now I would like to give this remote site wireless access via this 877w. Is there an example config anywhere as i just want to create an SSID and perhaps WPA-PSK authentication?

What I would love to do is authenticate users via a windows RADIUS server at the HQ.

Let me know if you wan the config attached.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
ivillegas Wed, 12/12/2007 - 07:17
User Badges:
  • Silver, 250 points or more

WPA-PSK configuration is supported on 877w. Here is a sample configuration on CLI

int dot0

encryption mode ciphers tkip


authentication open

authentication key-management wpa

wpa-psk ascii can be between 8 and 63 ASCI Itext characters

whiteford Wed, 12/12/2007 - 08:03
User Badges:

Thanks, I have added that and can see it, but don't get a DHCP address, how do I auto assign a DHCP address to the wireless users?

tu_amor66 Wed, 12/12/2007 - 14:00
User Badges:

Nat the scope you have assigned to the Vlan or network.

whiteford Wed, 12/12/2007 - 22:55
User Badges:

Hi, I'm not sure I understand, do you have an example? I have added the above example and my laptop sees the wireless network when I search, I put in the pre-shared key and authentcate, but it fails on assigning and IP.

I have a lan dhcp scope and a VLAN 1 which is my local router IP.

Let me know if you want the config uploaded.

edliu Sat, 01/19/2008 - 19:37
User Badges:

You must briging the Dot11Radio0 and Fe0.

Then let you lan dhcp server to assign IP adress.

Config example:

bridge-group 1

interface Dot11Radio0

bridge-group 1

int Fe0

bridge-group 1


This Discussion



Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode