Linksys CME

Unanswered Question
Dec 5th, 2007

Hi, How I can integrate the Linksys telephone, (model SPA922), to Cisco Call Manager Express, version 4.2. ?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Paolo Bevilacqua Wed, 12/05/2007 - 11:45

configure voice register dn and pool with the mac address and codec g711u. Configure voice register global. Configure the linksys accordingly. That's all what is required.

Paolo Bevilacqua Thu, 12/06/2007 - 05:17


any firmware on the linksys should be OK. Just enter configuration on the phone via web interface, assign the number and the IP address of the CME for registrar and proxy.

Hope this helps, please rate post if it does!

asantosp Wed, 03/19/2008 - 08:02

Can you guys post an example configuration of this type of integration?

I have an issue with the same scenario, CME 4.2 and Linksys Phone SPA922. I can make PSTN calls, but I cannot make internal calls between SPA922 phones.

Paolo Bevilacqua Wed, 03/19/2008 - 08:15

Likely the phones are not registered. Do "show sip-ua status registrar" to confirm.

To make phone register, assign user ID same as number, and password.


This Discussion