2811 with NM-2CE1T1-PRI module

Unanswered Question
Dec 5th, 2007

I have installed an NM-2CE1T1-PRI module in a Cisco 2811 router and issued the "card type T1 1" command as well as the "controller t1 1/0" and "controller t1 1/1" commands and sub-commands as required, however, the associated serial interfaces never get defined in the router. I am using IOS version:

c2800nm-advsecurityk9-mz.124-17a.bin

Any ideas?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
cconroy Wed, 12/05/2007 - 13:08

problem resolved .... channel-group command never dropped in from script .....

Actions

This Discussion