loopback testing?

Unanswered Question
Dec 5th, 2007
User Badges:

Hi Experts,


We have a CM pub & sub assigned to diff. vlan on our Core switch i.e. vlan 10 & 20.


When we do a ping to loopback, say 127.0.0.1 , the result is 10ms. both server have the same result.

Also when pinged it's own ip & gateway, 10ms still.


Now we tried our pc, where it belongs to vla 5, which gives us 1ms which is normal I assume.


Could the result of the 2 CMs abnormal?


Tia


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 3 (1 ratings)
Loading.
s.jankowski Wed, 12/12/2007 - 14:51
User Badges:
  • Bronze, 100 points or more

Verifying Enabling of Remote Loopback Testing:

To verify the loopback status of the current interface, after the far end has been put in loopback mode, enter the command show service-module serial replacing with the slot and port number of the serial interface.

http://www.cisco.com/en/US/products/ps6350/products_configuration_guide_chapter09186a0080455273.html#wp1032873


redrobish Wed, 12/12/2007 - 15:02
User Badges:

thanks s.jankowski.


it's the CM server not the Router.


Anyone?


Actions

This Discussion