12-06-2007 07:51 AM - edited 03-15-2019 07:38 AM
Hi,
I have Paolo Bevilacqua's wake-up service programmed as a script in my CME 4.1. All SCCP phones can reach the wake up service and use it, but SIP endpoints just give me a fast busy. Is there a special command that needs to be added to my configuration for TCL scripts to work with SIP phones?
Thanks.
Solved! Go to Solution.
12-06-2007 08:08 AM
Hi,
this due to a check in IOS that produces (erroneously in my opinion):
%CALL_CONTROL-6-CALL_LOOP: The incoming call has a global identfier already present in the list of currently handled calls. It is being refused.
The misspelling is not mine either :)
The workaround is to configure "session protocol cisco" under the DP, and "allow-connections sip to h323" under "voice service". Note, I use an _ivs image for this, not sure if it would work without.
12-06-2007 08:08 AM
Hi,
this due to a check in IOS that produces (erroneously in my opinion):
%CALL_CONTROL-6-CALL_LOOP: The incoming call has a global identfier already present in the list of currently handled calls. It is being refused.
The misspelling is not mine either :)
The workaround is to configure "session protocol cisco" under the DP, and "allow-connections sip to h323" under "voice service". Note, I use an _ivs image for this, not sure if it would work without.
12-06-2007 08:16 AM
Hi Paolo,
Yes, I forgot to include that error message - that is exactly what I was getting.
I'll try that when I have a minute. As always, you are an asset to this community :)
12-06-2007 08:20 AM
Thank you for the appreciation.
I found amazing that someone can bear with my funny pronunciation and mix of voices, sound volumes and time formats in that service :)
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide