LWAP Console Access

Unanswered Question
Dec 6th, 2007

Good Day!

I am aware of the controller command "config ap username 'user' password 'pass' all/cisco ap"

However I am wondering if it is possible to actually get a login prompt from the lwap console. Entering the command specifies a username, however you are not prompted for the username from the lwap console. I realize that you are a privilege 1 user, however I would like to prevent access from the Lwap console port completely.

Anyone know if this is possible?


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
drolemc Fri, 12/14/2007 - 07:14

This can be done by creating a local user database on the AP and then enabling login authentication. You will have to use the same commands as that of the router for enabling login authentication.


This Discussion



Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode