Load 8 port lic

Unanswered Question
suntzzu Fri, 12/14/2007 - 16:57
User Badges:

is this license specific to the switch in question?

mkoch Fri, 12/21/2007 - 02:39
User Badges:

Hi,


where did you get that license file?


These files are specific/locked to a certain MDS and cannot be copied from one MDS to the other.


regards,

Michael

I had the wrong host id in my lic file. I got a new lic file and it installed just fine.


When enter # show luc usage I see 24 port licenses, but when I enter show interface fc1/13 the response is port activation lic not available.


I also enter no shut interface fc1/13, do I need antoher command to active the lic on a per port bases?


Thanks,


amenh Thu, 03/13/2008 - 12:00
User Badges:

Make sure you've added "port-license acquire" to each interface you've licensed.


It will look like this in the running config:


foobar-fcsan-sw1# sh run int fc1/16

version 3.1(2)


interface fc1/16

port-license acquire

Actions

This Discussion

 

 

Trending Topics: Storage Networking