12-06-2007 01:22 PM
I have an 8 port lic file on my laptop. How do I install the lic on a MDS9124 switch?
I have tried the Fabric MGR GUI and I get the following error âError NotThisHost?
Thanks,
12-14-2007 04:57 PM
is this license specific to the switch in question?
12-21-2007 02:39 AM
Hi,
where did you get that license file?
These files are specific/locked to a certain MDS and cannot be copied from one MDS to the other.
regards,
Michael
12-21-2007 12:22 PM
I had the wrong host id in my lic file. I got a new lic file and it installed just fine.
When enter # show luc usage I see 24 port licenses, but when I enter show interface fc1/13 the response is port activation lic not available.
I also enter no shut interface fc1/13, do I need antoher command to active the lic on a per port bases?
Thanks,
03-13-2008 12:00 PM
Make sure you've added "port-license acquire" to each interface you've licensed.
It will look like this in the running config:
foobar-fcsan-sw1# sh run int fc1/16
version 3.1(2)
interface fc1/16
port-license acquire
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: