12-06-2007 01:38 PM - edited 03-17-2019 09:12 PM
I am connecting CCM to H323 VGW with E1 have 21279xx DOD range .The phone which have ext 79xx can only call outside . Is it possible to allow phone with other ext like 5xx to use this E1?
12-06-2007 02:25 PM
Hi Yousif,
Sure, we use numbers in the 5xxx,6xxx,7xxx and 8xxx all on a "shared" T1-PRI infrastructure :)
Hope this helps!
Rob
12-07-2007 08:53 AM
Hi Huffman,
pleasae find attached a copy from my vgw config and two debug files for two call as below:
1-calling nuber from ext 501"debug-callingnumber 501.txt "
2-calling number from ext 7901 -same range of E1- ""debug-callingnumber 7901.txt
the calls from 5xx not work but when I use 79xx ext it work with me.
is there way to change the Calling nuber to the one from Service provider "79xx" without change the ext "5xx"
12-07-2007 06:05 PM
If all you DNs are 5xx and the last two match the DID 79xx, then you can create a single voice translation-rule and apply it to a profile for your outgoing pots dial-peer:-
voice translation-rule 2
rule 1 /5/ /79/
!
voice translation-profile outgoing
translate calling 2
!
dial-peer voice 1010 pots
translation-profile outgoing outgoing
description local
destination-pattern [24]......
no digit-strip
port 0/0/0:1
!
This wil translate the 3 digit calling party DN 501 to 7901.
Hope this helps
Regards
Allan.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: