Buy or Renew
Buy or Renew
Cisco Virtual Engineer generative AI bot now active in Wireless Discussion Forum. Learn more.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
288
Views
0
Helpful
1
Replies

Aironet 1030 - ALARM state

J_Vansen_S
Level 3
Level 3

‎12-06-2007 07:18 PM - edited ‎07-03-2021 03:04 PM

Hi all

My AP stopped working totally when i power it off & on. It just shows ALARM on the LED. By right when power on first time, it should start flashing searching for WLC, but it is just lights up ALARM LED.

Is there anyway i can reset the AP without the WLC.

Plz advice

Labels:
0 Helpful
1 Reply 1

ericgarnel
Level 7
Level 7

‎12-07-2007 06:58 AM

Per the manual that comes with our 1000 series:

"The Red LED can light for about 10-20 seconds when it reboots. If the Red LED comes on and stays on for more than a minute, call TAC"

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card