5505 VPN to LinkSys WRV54G

Unanswered Question
Dec 7th, 2007
User Badges:

Hello, I'm new to the Cisco GUI (ASDM) and trying to configure a VPN between A 5505 and LinkSys WRV54G. I setup the tunnel following the manual, however I do not see a way to check the VPN status or logs via the GUI.


Do I need to go back to the command line to check the status? Is there a way to see if the VPN is or is not connect via the GUI?


Are there any publications to help better understand the ASA 5505 and VPN configurations?


Thanks:)

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
tdenham735 Fri, 12/07/2007 - 06:55
User Badges:

This seems even more odd (from cmd line view). I am looking at the config, but seems that when I setup a VPN via the GUI it's not complete. It appears to not work at all.


Please help if you have an experience with this new GUI on the 5505. I would like to use the GUI, but seems like I may be force back to command line if the GUI is actually broken?


Is the GUI broke? Does it actually work?


Thanks:)

whanson Fri, 12/07/2007 - 08:06
User Badges:

when you asdm in top of screen should have

a wizards there is one for site to site and for client

tdenham735 Fri, 12/07/2007 - 08:10
User Badges:

Yes...I see those, and I have setup a site to site VPN to talk to the LinkSys, however I have no clue if it's working or what the status is. How can I check the status? How can I make the VPN connect or does it just try by default?


Thanks:)

tdenham735 Fri, 12/07/2007 - 09:04
User Badges:

I am embarrased to admit this...but configuring the new ASA router via the wizard, I later found that a default gateway was not set! It's working now:) Jeesh!!!!


Basically that was my problem with connectivity, however I'm still unsure about how to check the tunnel status via the gui...


Any help would be appreciated:) Thanks.

Actions

This Discussion