ASA 5510 SVC Issues

Unanswered Question
Dec 8th, 2007
User Badges:


I have implemented an ASA 5510 with a single subnet behind the firewall,

I have followed all the instructions in cisco documentation and I can connect no problems to the VPN. I am assigned an IP address from the dhcp server

However the only thing I can see (using ping is the default gateway - which happens to be the ASA internal interface192.168.0.1.

I am tunneling all traffic through the tunnel and local lan is disabled.

My only route on the firewall is that points to our external router.

I have NO access rules or filters to prevent the traffic.

As I mentioned the only device I can see on the same subnet is the inside interface, any ideas as the routing on the internal subnet should already be known.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Jason Gervia Mon, 12/10/2007 - 11:38
User Badges:
  • Cisco Employee,

Without your configuration, I can't guess too much, but check your NAT acl to make sure that there is a nonat (nat 0) statement for your internal networks to your VPN pool.



This Discussion