cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
263
Views
0
Helpful
1
Replies

ASA 5510 SVC Issues

a.macready
Level 1
Level 1

Hi

I have implemented an ASA 5510 with a single subnet behind the firewall, 192.168.0.0/24

I have followed all the instructions in cisco documentation and I can connect no problems to the VPN. I am assigned an IP address from the dhcp server 192.168.0.100

However the only thing I can see (using ping is the default gateway - which happens to be the ASA internal interface192.168.0.1.

I am tunneling all traffic through the tunnel and local lan is disabled.

My only route on the firewall is 0.0.0.0 0.0.0.0 that points to our external router.

I have NO access rules or filters to prevent the traffic.

As I mentioned the only device I can see on the same subnet is the inside interface, any ideas as the routing on the internal subnet should already be known.

1 Reply 1

Jason Gervia
Cisco Employee
Cisco Employee

Without your configuration, I can't guess too much, but check your NAT acl to make sure that there is a nonat (nat 0) statement for your internal networks to your VPN pool.

--Jason

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: