12-09-2007 11:04 PM - edited 03-11-2019 04:41 AM
Hi,
I have two pix 515e firewalls running v7.2(3). They have a similar setup. On one pix outside has a small /29 ip block which routes a /25 and a /27. I've setup two static rules to allow traffic from a lower interface to higher levels. This works no problem. On the other pix however the setup is pretty much the same, with two exceptions. The ip block on outside is /30 And I making use of several VLANs. Strangely enough I don't need to setup required static rules for this to work. No nat is used I am using public ip addresses.
Can anybody explain why this is ?
Thanks in advance,
Toshio
12-10-2007 04:56 PM
Config please ?
12-10-2007 11:15 PM
Hi timkaye,
First off, thanks for attention. I found out, a few minutes ago that "nat-control" seems to be involved. I am little further now and I am going to investigate the problem with my new findings.
Kind Regards,
Toshio
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: