Solved: ASDM won't run

qbakies11 · ‎12-10-2007

I just got a new ASA 5510 and upgraded to ASA 8.0 using the ASDM. Then I upgraded the ASDM to 6.0 through the CLI using tftp. They both upgraded and loaded correctly as I can see them both listed when I do a 'sh ver' but nor I cannot connect to the ASDM.

I didn't change the management IP address (it's still 192.168.1.1) and I was able to hit it before the update. Now when I try to access it through a browser I get nothing but 'page cannot be displayed'. Can anyone help me with this?

husycisco · ‎12-11-2007

Hi Quantin

You are welcome. Please do not forget to check "resolved authors issue" for the comment.

Regards

View solution in original post

husycisco · ‎12-11-2007

Hi Quinton

Make sure http server enable command exists in config

Also issue the following commands in enable mode and please paste the results here.

dir

sh asdm image

Regards

qbakies11 · ‎12-11-2007

For some reason the 'http server enable' command was not in the config after I upgraded to ASA 8.0 so I added it and am now in the ASDM. Thank you very much for your help.

husycisco · ‎12-11-2007

Hi Quantin

You are welcome. Please do not forget to check "resolved authors issue" for the comment.

Regards