12-10-2007 01:06 PM - edited 03-11-2019 04:41 AM
I just got a new ASA 5510 and upgraded to ASA 8.0 using the ASDM. Then I upgraded the ASDM to 6.0 through the CLI using tftp. They both upgraded and loaded correctly as I can see them both listed when I do a 'sh ver' but nor I cannot connect to the ASDM.
I didn't change the management IP address (it's still 192.168.1.1) and I was able to hit it before the update. Now when I try to access it through a browser I get nothing but 'page cannot be displayed'. Can anyone help me with this?
Solved! Go to Solution.
12-11-2007 06:26 AM
Hi Quantin
You are welcome. Please do not forget to check "resolved authors issue" for the comment.
Regards
12-11-2007 02:25 AM
Hi Quinton
Make sure http server enable command exists in config
Also issue the following commands in enable mode and please paste the results here.
dir
sh asdm image
Regards
12-11-2007 06:08 AM
For some reason the 'http server enable' command was not in the config after I upgraded to ASA 8.0 so I added it and am now in the ASDM. Thank you very much for your help.
12-11-2007 06:26 AM
Hi Quantin
You are welcome. Please do not forget to check "resolved authors issue" for the comment.
Regards
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide