cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1032
Views
0
Helpful
3
Replies

2501 stuck in cold start

wuh
Level 1
Level 1

Hi, all.

I have a 2501 router. Everytime, when it starts, it stops, saying snmp agent on host router is undergoing a cold start...

even when it wouldnt stop when i type break to go Rommon mode.

what might be the problem. I've copied the message here.

===========

00:00:09: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0, changed state

to up

00:00:18: %LINEPROTO-5-UPDOWN: Line protocol on Interface Ethernet0, changed sta

te to down

00:00:20: %SYS-5-CONFIG_I: Configured from memory by console

00:00:23: %LINK-5-CHANGED: Interface Serial0, changed state to administratively

down

00:00:23: %LINK-5-CHANGED: Interface Serial1, changed state to administratively

down

00:00:26: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0, changed state

to down

00:00:26: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial1, changed state

to down

00:01:04: %SYS-5-RESTART: System restarted --

Cisco Internetwork Operating System Software

IOS (tm) 2500 Software (C2500-IO-L), Version 12.2(26), RELEASE SOFTWARE (fc2)

Copyright (c) 1986-2004 by cisco Systems, Inc.

Compiled Sat 31-Jul-04 03:32 by eaarmas

00:01:04: %SNMP-5-COLDSTART: SNMP agent on host Router is undergoing a cold star

tˇ

System Bootstrap, Version 11.0(10c), SOFTWARE

Copyright (c) 1986-1996 by cisco Systems

2500 processor with 16384 Kbytes of main memory

F3: 9286440+846656+770252 at 0x3000060

Restricted Rights Legend

Use, duplication, or disclosure by the Government is

subject to restrictions as set forth in subparagraph

(c) of the Commercial Computer Software - Restricted

Rights clause at FAR sec. 52.227-19 and subparagraph

(c) (1) (ii) of the Rights in Technical Data and Computer

Software clause at DFARS sec. 252.227-7013.

cisco Systems, Inc.

170 West Tasman Drive

San Jose, California 95134-1706

Cisco Internetwork Operating System Software

IOS (tm) 2500 Software (C2500-IO-L), Version 12.2(26), RELEASE SOFTWARE (fc2)

Copyright (c) 1986-2004 by cisco Systems, Inc.

Compiled Sat 31-Jul-04 03:32 by eaarmas

Image text-base: 0x03050A44, data-base: 0x00001000

cisco 2500 (68030) processor (revision A) with 16384K/2048K bytes of memory.

Processor board ID 01207578, with hardware revision 00000000

Bridging software.

X.25 software, Version 3.0.0.

1 Ethernet/IEEE 802.3 interface(s)

2 Serial network interface(s)

32K bytes of non-volatile configuration memory.

16384K bytes of processor board System flash (Read ONLY)

Press RETURN to get started!

00:00:07: %LINK-3-UPDOWN: Interface Ethernet0, changed state to up

00:00:08: %LINK-3-UPDOWN: Interface Serial0, changed state to up

00:00:08: %LINK-3-UPDOWN: Interface Serial1, changed state to down

00:00:09: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0, changed state

to up

00:00:18: %LINEPROTO-5-UPDOWN: Line protocol on Interface Ethernet0, changed sta

te to down

00:00:20: %SYS-5-CONFIG_I: Configured from memory by console

00:00:21: %LINK-5-CHANGED: Interface Serial0, changed state to administratively

down

00:00:23: %LINK-5-CHANGED: Interface Serial1, changed state to administratively

down

00:00:23: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0, changed state

to down

00:00:26: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial1, changed state

to down

00:01:04: %SYS-5-RESTART: System restarted --

Cisco Internetwork Operating System Software

IOS (tm) 2500 Software (C2500-IO-L), Version 12.2(26), RELEASE SOFTWARE (fc2)

Copyright (c) 1986-2004 by cisco Systems, Inc.

Compiled Sat 31-Jul-04 03:32 by eaarmas

00:01:04: %SNMP-5-COLDSTART: SNMP agent on host Router is undergoing a cold star

tˇ

+++++++++++STOPS HERE, then i reboot it.

3 Replies 3

glen.grant
VIP Alumni
VIP Alumni

Are you saying that it starts rebooting over and over by itself ? Otherwise that is a normal end of boot message meaning it is ready to configure , just hit the enter key at that point.

No, it is rebooting over and over. it just freezes there. then after I reboot, it does the same thing.

Sorry, a typo. Please ignore the last message i added. it should be.

No, it is NOT rebooting over and over. it just freezes there. then after I reboot, it does the same thing.

thanks,

Review Cisco Networking products for a $25 gift card