Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
866
Views
0
Helpful
2
Replies

2800 series failover/load balancing fiber

m.korbee
Level 1
Level 1

‎12-11-2007 02:35 AM - edited ‎03-03-2019 07:52 PM

Hi, I am looking for info about the following. A customer wants an 2800 router configured with two ISP lines. Pref 2 Fiber lines, configured with at least failover but if possible also loadbalancing. Can someone tell me what is needed for this, or if it is possible. Or is it only possible with fiber and xDSL? I tried to contact Cisco (we are partner) but I cannot contact anyone who can tell me this....

Labels:
0 Helpful
2 Replies 2

jean.christophe
Level 1
Level 1

‎12-11-2007 03:44 AM

Hi,

Why don't you consider doing the load-balancing/failover through routing protocols between the 2800 and the ISPs?

0 Helpful

Hashmatmutaher
Level 1
Level 1
In response to jean.christophe

‎12-11-2007 04:02 AM

hi

how can i block single IP and can i block sites of one IP or not give me Inf and configuration ways? Cisco 2801 router

regards

Hashmatullah

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card