nat an entire subnet destination address

Unanswered Question
Dec 11th, 2007

see attached .ppt. I have a satellite service in which the provider must provide ip addressing, which is no good to me. I need to nat entire destination subnet to providers network, then nat it back at the remote site. see attached.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
pstebner10 Thu, 12/13/2007 - 11:27

Can you just assign a 192.x.x.x address to the outside interfaces of both of your routers and PAT off of those, leaving your 10.x.x.x schemes intact?

jmyatt209 Thu, 12/13/2007 - 14:00

No, WAN ip addresses are assigned by provider. Found a resolution in the meantime, just had to make the WAN network the nat inside the do a static network nat.

Actions

This Discussion