12-11-2007 08:35 PM - edited 03-03-2019 07:53 PM
see attached .ppt. I have a satellite service in which the provider must provide ip addressing, which is no good to me. I need to nat entire destination subnet to providers network, then nat it back at the remote site. see attached.
12-13-2007 11:27 AM
Can you just assign a 192.x.x.x address to the outside interfaces of both of your routers and PAT off of those, leaving your 10.x.x.x schemes intact?
12-13-2007 02:00 PM
No, WAN ip addresses are assigned by provider. Found a resolution in the meantime, just had to make the WAN network the nat inside the do a static network nat.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: