error starting IOS on 3660 cisco router

Unanswered Question
Dec 12th, 2007

i've upgraded 3660 router flash memory from 8 mb to 2x32 flash simm i uploaded ios version 12.1 from xmodem -r its size 5 mb, upload process completed successfully and the router booted normally cuz the IOS on the DRAM

after that i uploaded another version of IOS 12.3 after finished upload the router booted and an error message interrupted the boot process

"*** Bus Error (Load) Exception ***

Access address = 0x8e032958

PC = 0x8000b740, Cause = 0x401c, Status Reg = 0x3041f003

*** CPU Out-of-range Interrupt ***

Access address high = 0x0, low = 0xe032958

PC = 0xbfc10134, Cause = 0x4000, Status Reg = 0x3041f003

monitor: command "boot" aborted due to exception"

so please advise what to do

thanks in advanced

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
JORGE RODRIGUEZ Wed, 12/12/2007 - 15:24

Indeed not the kind of messages one likes to see when upgrading codes, does the route goes into rommon> if it does try recoverying , here is a link for rommon recovery..

http://www.cisco.com/en/US/docs/routers/access/3600/hardware/installation/guide/3600appB.html

Take a look at ios bugs on 12.3 and your platform to rule out issue with code and 3660 , if you try to xmodem another image re-donwload a fresh code from cisco before downloading it to router.

HTH

jorge

Actions

This Discussion