top 10 access rules

Unanswered Question
Dec 12th, 2007

Hi,

My configuration I have 2 asa 5510 as A/P failover.

In "top 10 access rules" I have a rule with a blank interface and src =any dest =any service =http action =permit

With right click I have no information.

I don't know where I use this rule and is it the failover rule ?

And I have an other question, what's the tcp ou udp port of failover link.

Regards

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
mark.j.hodge Tue, 01/08/2008 - 07:09

I believe this is an implicit access-list, which allows traffic from a higher security interface to a lower security interface. I don't think it has anything to do with failover.

I'm not sure what protocol/ports are used for failover, but I suspect there will be a range for state, heartbeat and config syncronisation.

** Please rate posts if helpfull **

Actions

This Discussion