WLC Issue

Unanswered Question
Dec 12th, 2007

I configured a WLC 2000 with one WLAN using the management interface as access to the wireless. I am using a ASA 5505 as my DHCP server. The management interface is using port 4 to connect to port 7 on my ASA 5505. I am able to authencitcate and associate to the WLAN, however, i am not able to get dynamic address. If i enter a static address into my laptop,I can browse the internet. My management interface VLAN identifier (vlan 0)is untagged. The access point is connected to the ASA on port 3. Any reasons why i am unable to acquire a ip address dynamically from my ASA?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
ericgarnel Wed, 12/12/2007 - 08:53

2 ideas/questions

did you enable dhcpd on the ASA interface ?

did you specify the ASA ip in the controller interface or wlan configuration?

gomeso Wed, 12/12/2007 - 09:57

Yes, i enabled dhcpd on the ASA interface (inside)and specified the ASA ip in the controller and wlan configuration.


This Discussion



Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode