Buy or Renew
Buy or Renew
Cisco Virtual Engineer generative AI bot now active in Wireless Discussion Forum. Learn more.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
352
Views
0
Helpful
2
Replies

WLC Issue

gomeso
Level 1
Level 1

‎12-12-2007 08:17 AM - edited ‎07-03-2021 03:05 PM

I configured a WLC 2000 with one WLAN using the management interface as access to the wireless. I am using a ASA 5505 as my DHCP server. The management interface is using port 4 to connect to port 7 on my ASA 5505. I am able to authencitcate and associate to the WLAN, however, i am not able to get dynamic address. If i enter a static address into my laptop,I can browse the internet. My management interface VLAN identifier (vlan 0)is untagged. The access point is connected to the ASA on port 3. Any reasons why i am unable to acquire a ip address dynamically from my ASA?

Labels:
0 Helpful
2 Replies 2

ericgarnel
Level 7
Level 7

‎12-12-2007 08:53 AM

2 ideas/questions

did you enable dhcpd on the ASA interface ?

did you specify the ASA ip in the controller interface or wlan configuration?

0 Helpful

gomeso
Level 1
Level 1
In response to ericgarnel

‎12-12-2007 09:57 AM

Yes, i enabled dhcpd on the ASA interface (inside)and specified the ASA ip in the controller and wlan configuration.

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card