Non ETH lines - BW/speed requirement - LWAP to WController reg./comm.

Unanswered Question
Dec 13th, 2007

Not long ago I search some non wireless information and I found some document on Cisco WEB, which say about LWAP to WCotroller communication sensitivity and minimal troughput requirement. There was an info about "serial" line BW bandwidth/speed requirement - LWAP to WController registration/communication. Can anyone say me anything else about it?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Anonymous (not verified) Thu, 12/20/2007 - 06:41

Make sure the time/date is correct on the controller.Give it a couple of minutes to see if the AP joins.

If that doesnt solve the problem, place the controller in master controller mode, once again give it a couple of minutes.

If they still wont join, upgrade the controller code

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode