Need assistance with FXO ports

Unanswered Question
Dec 13th, 2007
User Badges:

I have a 2801 router with a 4 port FXO card in it. I have four POT lines coming into the router. I need some help with sending calls to the ports, can someone post configs on how to have the router send calls from my CCM to the POT lines?

Thanks,

Adam

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 1 (1 ratings)
Loading.
Brandon Buffin Thu, 12/13/2007 - 11:40
User Badges:
  • Purple, 4500 points or more

Adam,

The following documents will show you how to configure your gateway to work with CCM using MGCP. One caveat to keep in mind is that you cannot use caller ID with MGCP FXO ports. If you need caller ID, you'll need to configure the gateway to use H.323.


Configuring the Cisco IOS MGCP Gateway

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a008017787b.shtml


Configure MGCP Gateway and FXO/FXS Ports on a Cisco CallManager Server

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a008017825e.shtml


Hope this helps. If so, please rate the post.


Brandon

ahab Thu, 12/13/2007 - 11:48
User Badges:

If possible I would prefer to use H323. But If that route doesn't work I will try the MGCP route.

Actions

This Discussion