AP web access

Unanswered Question
htarra Thu, 12/20/2007 - 12:44
User Badges:
  • Bronze, 100 points or more

I am not sure it is avaivable in the CLI or not but in GUI you can. According to the notes in the case you need to access the AP using the GUI. If this is a brand new AP, the first thing you would need to do is to connect to the AP using the Console port, meaning to use a Hyper Terminal session and assigning the IP address of the AP.

These are the steps for this:

AP# configure terminal

AP(config)# interface bvi 1

AP(config-if)# ip address A.B.C.D

AP(config-if)# exit

AP(config)# exit

AP# wr

Once you enter this using the Console connection you would be able to connect a crossover cable to the AP and access it using the GUI.

tu_amor66 Thu, 12/27/2007 - 07:08
User Badges:

I agree with htarra, but from my experience a crossover cable is not necessary. I have used a straight-thru patch cable. Also the default IP on the AP should allow you to access without adding an IP address to it.


This Discussion