Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
380
Views
0
Helpful
3
Replies

Setup a CCM 5.1 Unix Loopback

jamesek
Level 1
Level 1

‎12-13-2007 02:33 PM - edited ‎03-13-2019 04:48 PM

Can a loopback address be set on CCM 5.1? I am trying to setup a server cluster using SLB with two 6500 core switches to allow a third party redundant connection.

Labels:
0 Helpful
3 Replies 3

smalkeric
Level 6
Level 6

‎12-20-2007 01:53 PM

Are you tryig to configure loopback address for h.323 gateway and put the loopback ip address in the callmanager's gateway configuration page?

0 Helpful

jamesek
Level 1
Level 1
In response to smalkeric

‎12-20-2007 02:02 PM

No. I am trying to setup SLB between the two callmanagers and one of the methods of SLB requires a loopback address on the CCM. I think I am going to use the direct method of SLB which does not requre loopback addresses.

Thanks

0 Helpful

Tim Smith
Level 4
Level 4

‎01-22-2008 07:27 AM

Hi..

You cant set a loopback as such..

But you can multihome the server to 2 x different switches

You will need to enable NFT from the command line on the CallManager.

It will use an active / standby config. I.e. if one link fails and the server detects it, it will attempt to activate the other link.

Cheers,

Tim.

0 Helpful
Customers Also Viewed These Support Documents