cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
371
Views
0
Helpful
3
Replies

Setup a CCM 5.1 Unix Loopback

jamesek
Level 1
Level 1

Can a loopback address be set on CCM 5.1? I am trying to setup a server cluster using SLB with two 6500 core switches to allow a third party redundant connection.

3 Replies 3

smalkeric
Level 6
Level 6

Are you tryig to configure loopback address for h.323 gateway and put the loopback ip address in the callmanager's gateway configuration page?

No. I am trying to setup SLB between the two callmanagers and one of the methods of SLB requires a loopback address on the CCM. I think I am going to use the direct method of SLB which does not requre loopback addresses.

Thanks

Tim Smith
Level 4
Level 4

Hi..

You cant set a loopback as such..

But you can multihome the server to 2 x different switches

You will need to enable NFT from the command line on the CallManager.

It will use an active / standby config. I.e. if one link fails and the server detects it, it will attempt to activate the other link.

Cheers,

Tim.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: