12-13-2007 09:16 PM - edited 03-17-2019 09:13 PM
Hi All,
My Customer say that CCME can not trunk to CCM5, Is it True?
From My understanding,
as long as the dial peer on CCME is done, it should be ok.
Assuming CCME extension is 10..
and the call manager side is 20..
On the CCME
dial-peer voice 1000 voip
destination-pattern 20..
session target 10.1.1.1
dtmf-relay h245-alphanumeric
What Should be done at the CallManager Side? A trunk ?
Is there any more config that should be done at the CCME ?
12-14-2007 07:35 AM
I haven't tried this with this version of CCM, but it should work fine. It can either be done with a trunk or a gateway on the CCM side. Make sure the codec is the same on both sides or that there is a transcoder available. Also, on CCME, you will need an incoming dial peer for calls from CCM to CCME.
Hope this helps.
Brandon
12-14-2007 04:06 PM
Hmm...
Curious, why is a incoming dial-peer be configure, for the simplest setup
Should not the dial peer be create in the CCM?
12-17-2007 06:39 AM
For incoming calls from CCM to CCME an incoming dial peer is required on the gateway. There are no dial peers created in CCM, only route patterns.
Brandon
12-19-2007 12:59 PM
Adding your CME box as a H.323 gateway in CCM will be the easiest way to manage that connection.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: