Multiple SSID on 1242

Unanswered Question
Dec 14th, 2007
User Badges:

Dear Sirs.

I have 1242AG access point. I need to create two SSIDs for different types of devices. I create one SSID with WPA TKIP security and another one without security. I create two VLANs for each SSID, one of the VLANs is native VLAN.

In event log I see that devices associate to both SSIDs. However, I can ping from the network only the device which is assigned to Native VLAN.

When I switch Native VLAN to another SSID, devices within this SSID are being seen from the network, devices within second SSID are not seen (and vice versa).

Pleae advise.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Richard Atkin Fri, 12/14/2007 - 17:25
User Badges:
  • Silver, 250 points or more

Could be a whole host of things... Easiest option is to post the switchport config from the switch, and the AP config.


Failing that, check that...


VLAN tags & encapsulation types are correct.

Routing is setup correctly

No ACLs / Firewalls

Bridge Groups setup correctly (Native VLAN is normally reserved for BVI 1, and not mapped to an SSID)

Actions

This Discussion