Problem in Transfer

Unanswered Question
Dec 14th, 2007


i have CME, i want when i must to transfer outgoing call to inetrnal phone, i didn't need to wait that the outgoing destination answers to call.

how can i do this ?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
allan.thomas Fri, 12/14/2007 - 08:29

Reading between the lines I believe you need to configure transfer-system blind or full-blind under the telephony service.

To specify the call transfer method to be used by Cisco Unified IP phones in Cisco Unified CME, use the transfer-system command in telephony-service configuration mode.

See the following link for further details:-

Hope this helps



Pls rate helpful posts.

Paolo Bevilacqua Fri, 12/14/2007 - 08:37

Hi, beside the advice given by Allan, remember that to use blind transfer on system configured for consultive, just hang up, or press transfer again, after completing the number you want to transfer to.


This Discussion