12-14-2007 07:59 AM - edited 03-15-2019 07:47 AM
Hy,
i have CME, i want when i must to transfer outgoing call to inetrnal phone, i didn't need to wait that the outgoing destination answers to call.
how can i do this ?
12-14-2007 08:29 AM
Reading between the lines I believe you need to configure transfer-system blind or full-blind under the telephony service.
To specify the call transfer method to be used by Cisco Unified IP phones in Cisco Unified CME, use the transfer-system command in telephony-service configuration mode.
See the following link for further details:-
http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/command/reference/cme_t1ht.html#wp1084962
Hope this helps
Regards
Allan.
Pls rate helpful posts.
12-14-2007 08:37 AM
Hi, beside the advice given by Allan, remember that to use blind transfer on system configured for consultive, just hang up, or press transfer again, after completing the number you want to transfer to.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide