Show connections on a 1721

Answered Question
Dec 14th, 2007
User Badges:

I currently have a site connected via a T1 and it is getting flooded. Is there a command that I can run on the 1721 Router that will show all connections so that I can identify the source / destination IP addresses of all traffic? I tried "show connections" but that didn't have the info that I needed.


Thanks in advance!

Correct Answer by Edison Ortiz about 9 years 5 months ago
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
TrueFX Fri, 12/14/2007 - 08:23
User Badges:

Attached is the 'show version'


Cisco Internetwork Operating System Software

IOS (tm) C1700 Software (C1700-K9O3SY7-M), Version 12.2(8)T1, RELEASE SOFTWARE (fc2)

TAC Support: http://www.cisco.com/tac

Copyright (c) 1986-2002 by cisco Systems, Inc.

Compiled Sat 30-Mar-02 14:18 by ccai

Image text-base: 0x80008108, data-base: 0x80D2C08C


ROM: System Bootstrap, Version 12.2(7r)XM1, RELEASE SOFTWARE (fc1)


pob-1721 uptime is 23 minutes

System returned to ROM by reload at 09:56:54 CST Fri Dec 14 2007

System restarted at 09:58:24 CST Fri Dec 14 2007

System image file is "flash:c1700-k9o3sy7-mz.122-8.T1.bin"


cisco 1721 (MPC860P) processor (revision 0x100) with 44237K/4915K bytes of memory.

Processor board ID FOC06150DEF (1625455792), with hardware revision 0000

MPC860P processor: part number 5, mask 2

Bridging software.

X.25 software, Version 3.0.0.

1 FastEthernet/IEEE 802.3 interface(s)

1 Serial network interface(s)

1 Virtual Private Network (VPN) Module(s)

WIC T1-DSU

32K bytes of non-volatile configuration memory.

16384K bytes of processor board System flash (Read/Write)


Configuration register is 0x2102


TrueFX Fri, 12/14/2007 - 08:51
User Badges:

I type the following :


config t

int se 0

ip flow ingress

--- Unknown command


I don't think my router supports netflow.

TrueFX Fri, 12/14/2007 - 09:27
User Badges:

Thank you so much! I was able to use the Netflow data to track down the culprit!


I can tell that I will be using this a lot in the future!

TrueFX Fri, 12/14/2007 - 08:30
User Badges:

As far as IP Accounting, we don't have any ACLs on the system, and it looks like IP Accounting only tracks failures agains the ACLs. Is that correct?


Thanks

Edison Ortiz Fri, 12/14/2007 - 08:36
User Badges:
  • Super Bronze, 10000 points or more
  • Hall of Fame,

    Founding Member

No, you can implement ip accounting without any ACLs.

Actions

This Discussion