Frame-Relay Switching Again?

Unanswered Question
Dec 15th, 2007
User Badges:

Hello All,

I am receiving the following error message on a router intended for the frame-relay switching. Even though the router has been configured as a FRAME RELAY SWITCHING. Though i did not configure any IP on the interface as i don't need one to the best of my knowledge or am i wrong? or where am i missing something out? please help me.

HERE IS THE ERROR MESSAGE ( the cable side is DCE already)

"Router(config-if)#clock rate 56000

%Error: This command applies only to DCE interfaces

Router(config-if)#

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Edison Ortiz Sat, 12/15/2007 - 15:38
User Badges:
  • Super Bronze, 10000 points or more
  • Hall of Fame,

    Founding Member

show controller serial x/x | i DTE|DCE


should tell you if the interface is acting as DCE or DTE.



Actions

This Discussion